LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Wagoneer Carbide, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (6.4L - Starting System (Service Information)) >> Antenna, Remote Start >> Removal And Installation >> Remote Start Antenna

Remote Start Antenna

WARNING: This page is about a different car, the 2023 Jeep Grand Wagoneer. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL 

  1. Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECT - SINGLE 12V BATTERY SYSTEM, 5.7L & 6.4L .
  2. Lower the headliner far enough to gain access to the Remote Start Antenna (RSA). Refer to HEADLINER, REMOVAL AND INSTALLATION .
    GC0205558Courtesy of CHRYSLER GROUP, LLC
    1 - Remote Start Antenna Connection
    2 - Remote Start Antenna Push Pin
    3 - Remote Start Antenna
  3. Disconnect the RSA wire harness connector.
  4. Remove the two fasteners.
  5. Remove the RSA from the vehicle.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle.