Engine Assembly: Installation

WARNING: This page is about a different car, the 2023 Jeep Grand Wagoneer. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

If the original engine has experienced a catastrophic failure or an individual failure with the piston, cylinder bore, engine block, valve or valve seat, the intake manifold MUST be replaced with a new manifold.

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

If required, transfer any necessary components for installation onto the replacement engine.
Install the engine lift fixture and adapter to the new engine for installation.
The structural dust cover bolts must be tightened in the sequence described in the torque table below to avoid damaging the cover.
Fill the engine with oil and replace the oil filter. Refer to 6.4L ENGINE, CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS .
Fill the cooling system.
Start the engine and check for leaks.

NOTE:

The Cam/Crank Variation Relearn procedure must be performed using the scan tool anytime there has been a repair/replacement made to a powertrain system, for example: flywheel, valve train, camshaft and/or crankshaft sensors or components.