LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Wagoneer Carbide, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (6.4L - Engine (Service Information) (3 Of 3)) >> Fuel System >> Standard Procedure >> Draining Fuel Tank >> Alternative Procedure

Alternative Procedure

WARNING: This page is about a different car, the 2023 Jeep Grand Wagoneer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If the electric fuel pump is not operating, the fuel tank must be removed and drained through the fuel pump module opening of the fuel tank.

  1. Perform the Fuel System Pressure Release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE  .
  2. Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECT - SINGLE 12V BATTERY SYSTEM .
  3. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  4. Remove the fuel tank. Refer to TANK, FUEL, REMOVAL AND INSTALLATION .
    GC0184967Courtesy of CHRYSLER GROUP, LLC
    1 - Fuel Pump Module
    2 - O-ring
  5. Remove the fuel pump module. Refer to ASSEMBLY, FUEL PUMP, REMOVAL AND INSTALLATION .
  6. Position a 3/8" hose into the fuel pump module opening of the fuel tank.
  7. Attach the opposite end of this hose to the Fuel Chief Gas Caddy 320-FC-P30-A or an OSHA approved gas caddy.
  8. Using the gas caddy, evacuate the fuel tank.
scientia non olet · About LEMON Manuals