Torque Specifications - Engine Sensors
WARNING: This page is about a different car, the 2023 Jeep Grand Wagoneer L and 2023 Jeep Grand Wagoneer. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE SENSORS (1 OF 3)
| CALLOUT | DESCRIPTION | SPECIFICATION | COMMENT |
|---|---|---|---|
| 1 | Camshaft Position (CMP) Sensor(s) | 9 N.m (80 In. Lbs.) | Install heat shield on the exhaust cam sensor |
| 2 | Knock Sensor 3 | 22 N.m (16 Ft. Lbs.) | Do not reuse fastener. If removed, a new fastener must be installed. Bolt should be hand started. |
| 3 | Engine Coolant Temp (ECT) Sensor | 22 N.m (16 Ft. Lbs.) | - |
| 4 | Knock Sensor 2 | 22 N.m (16 Ft. Lbs.) | Do not reuse fastener. If removed, a new fastener must be installed. Bolt should be hand started. |
| 5 | Knock Sensor 1 | 22 N.m (16 Ft. Lbs.) | Do not reuse fastener. If removed, a new fastener must be installed. Bolt should be hand started. |
| 6 | Throttle Inlet Pressure/Temp Sensor | Clips into place | - |
| 7 | Engine Oil Pressure/Temp (EOP) Sensor Bolt | 10 N.m (7 Ft. Lbs.) | - |
| 8 | Crankshaft Position (CKP) Sensor | 11 N.m (8 Ft. Lbs.) | - |
| - | Knock Sensor Wire Harness Retaining Bolt | 23 N.m (19 Ft. Lbs.) | - |
ENGINE SENSORS (2 OF 3)
| CALLOUT | DESCRIPTION | SPECIFICATION | COMMENT |
|---|---|---|---|
| 1 | Crankcase Pressure Sensor | Clips into place | - |
| 2 | Mass Airflow (MAF) Sensor | Tighten Securely | - |
| 3 | Manifold Absolute Pressure (MAP) Sensor | 5 N.m (80 In. Lbs.) | - |
| 4 | Fuel Rail Pressure (FRP) Sensor | 33 N.m (24 Ft. Lbs.) | - |
ENGINE SENSORS (3 OF 3)
| CALLOUT | DESCRIPTION | SPECIFICATION | COMMENT |
|---|---|---|---|
| 1 | Oil Level Sensor Bolts | Torque Procedure:
|
- |
| 1-1, 1-2, 2-1, 2-2 | Oxygen Sensors | 50 N.m (37 Ft. Lbs.) | - |