Sunroof Or Sunshade Obstacle Detection Override: Notes

There are two methods for overriding the obstacle detection of the sunroof or power sunshade. If sunroof or power sunshade is experiencing auto-reversals but no obstacle is present in roof opening standard procedure Dual Pane Calibrations SUNROOF INITIALIZATION AND OBSTACLE DETECTION CALIBRATION should be followed.

• OVERRIDE - METHOD 1  - Press and hold the sunroof or sunshade CLOSE switch. Obstacle detection is not active during manual (press & hold switch) operation of the sunroof or power sunshade.
• OVERRIDE - METHOD 2  - If the sunroof or power sunshade auto-reverses three consecutive times during express (one touch) close operation, the sunroof will enter override mode. All switch commands will be in manual mode (one-touch express operation will be disabled) while the obstacle detection feature is in override mode. Sunroof or power sunshade must be fully closed in manual mode (press & hold switch) or vehicle ignition cycled off and back on to exit override mode.