LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Renegade Red >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 1.3L Engine (Service Information) (2 Of 2) >> Lubrication >> Cooler, Oil >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Position the engine oil cooler with a new metal seal onto the engine and loosely install the bolts.
    Fig 1: Engine Oil Cooler Bolts Tightening Sequence
    GC0188779Courtesy of CHRYSLER GROUP, LLC
  2. Tighten the bolts in the sequence shown in illustration to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  3. Install the coolant inlet hose to the engine oil cooler and tighten the band clamp.
  4. Install the water pump inlet tube. Refer to PUMP, WATER, REMOVAL AND INSTALLATION .
  5. Install the accessory drive belt tensioner. Refer to TENSIONER, BELT, REMOVAL AND INSTALLATION .
  6. Install the generator. Refer to GENERATOR, REMOVAL AND INSTALLATION .
  7. Install the clean air hose. Refer to HOSE, CLEAN AIR, REMOVAL AND INSTALLATION .
  8. Fill the engine cooling system. Refer to DRAINING AND FILLING THE COOLING SYSTEM - 1.3L .
  9. Connect the negative battery cable.
  10. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals