LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Renegade Red >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 1.3L Engine (Service Information) (2 Of 2) >> Cylinder Head >> Rocker Arm, Valve >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Check that the pins are clean.
    GC0200060Courtesy of CHRYSLER GROUP, LLC
  2. Install the NEW  rocker arms (2a) between the cover lever (2b) and camshaft.
  3. Position the recess (3a) on the rocker arm on the head of the pin (1).
  4. Push the rocker arm (2a) lightly onto the pin (1) to engage the retaining clip (4a).
  5. Install the Variable Valve Actuator Assembly (VVAA). Refer to ASSEMBLY, VARIABLE VALVE ACTUATION, REMOVAL AND INSTALLATION  .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals