Set Condition

WARNING: This page is about a different variant/trim than selected.

The failure is detected if the measured directions of input speed and output speed signal do not correspond to the calculated driving direction for a calibrated amount of time.
- Condition 1:
  - The Input Speed Sensor direction is forward and the Output Speed Sensor direction is backward or the Input Speed Sensor detects reverse direction while the coast mode is active and the Output Speed Sensor direction is backward.
- Condition 2:
  - The Input Speed Sensor direction is reverse and the Output Speed Sensor direction is forward or the Input Speed Sensor detects forward direction while the coast mode is active and the Output Speed Sensor direction is forward.