Set Condition
WARNING: This page is about a different variant/trim than selected.
- The calculated solenoid current is less than a calibrated lower threshold or greater than a calibrated upper threshold for 0.05 second.
- The captured Pulse Width Modulated (PWM) periods are greater than or less than a calibrated threshold for 0.05 second.
- The captured PWM on time is greater than 0 and the specified solenoid current of the active cycle is equal to 0 for 2.6 seconds.
- The captured PWM on time is equal to 0 and the specified solenoid current of the active cycle is not equal to 0 for 2.6 seconds.