When Monitored

WARNING: This page is about a different variant/trim than selected.

This diagnostic runs continuously when the following condition is met:

Ignition on.
No electrical failures detected in the transmission speed sensors.
No CAN Bus or internal failures of the Wheel Speed Sensors.
Engine speed signal is valid.
Transfer Case is not shifting.
Transmission is in a fixed gear.
BUS signals are available.
Limp Home mode is not active.
No vehicle stability intervention is active in low range while braking.
No sensor supply voltage Diagnostic Trouble Codes (DTCs) set.
No failure detected for Intermediate Shaft Speed Sensor circuit.