Set Condition

This DTC sets when one or more of the following conditions are present:

• The actual engine torque request and the delivered engine torque sent via BUS is greater than a calibrated value when the transmission is not in PARK or Neutral and there is no gearshift in progress.
• A positive torque request is sent via the CAN Bus and no positive torque request was calculated by the shift control software.
• The actual engine torque request is less than a calibrated value and the difference between actual engine torque and requested engine torque is greater than a calibrated value when the transmission is not in PARK or Neutral and there is a gearshift in progress.
• The actual input speed and output speed gradient is less than a calibrated value when the transmission is not in PARK or Neutral, there is a gearshift in progress and a positive torque request is active.
• Positive engine torque is transmitted when no positive engine torque is commanded by the shift control software and the absolute transmitted engine torque request is greater than engine torque request commanded by the shift control software.
• The shift control software commands a non-negative engine torque request and the TCM transmits a negative torque request.
• The maximum allowed combustion engine torque for the hybrid powertrain is less than a calibrated value.
• A negative torque request is sent via the CAN Bus and no negative torque request was calculated by the shift control software.