Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN
- With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
- For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
- With the scan tool, erase all DTCs.
- Turn the ignition off for a minimum of 10.0 seconds.
- Turn the ignition on.
- Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read DTCs.
Did the DTC return?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
- CHECK THE BRAKE SYSTEM CONTROL MODULE FOR WHEEL SPEED SENSOR FAULTS
- With the scan tool, read DTCs in the BSCM.
Is the BSCM setting any DTCs against a Wheel Speed Sensor?
Yes
- Perform the diagnostic procedure in the BSCM. Refer to: BRAKE SYSTEM CONTROL MODULE (BSCM) - DIAGNOSTIC CODE INDEX .
No
- Replace the BSCM in accordance with the Service Information. Refer to MODULE, BRAKE SYSTEM CONTROL (BSCM), REMOVAL AND INSTALLATION or MODULE, BRAKE SYSTEM CONTROL 2 (BSCM2), REMOVAL AND INSTALLATION .
- With the scan tool, read DTCs in the BSCM.