Battery Disconnect And Connect - Single Battery

WARNING: This page is about a different variant/trim than selected.

DISCONNECT

Remove the rear floor heat duct. Refer to DUCT, FLOOR DISTRIBUTION, REAR, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC

1 - Negative Battery Cable
Disconnect the Intelligent Battery Sensor (IBS) wire harness connector.
Press and release the negative battery cable.

CONNECT

Courtesy of CHRYSLER GROUP, LLC

1 - Negative Battery Cable

Press and install the negative battery cable onto the IBS stud.
Connect the IBS wire harness connector.
Install the rear floor heat duct. Refer to DUCT, FLOOR DISTRIBUTION, REAR, REMOVAL AND INSTALLATION .