Transmission To Transmission Oil Cooler Tubes: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the air cleaner assembly. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION - 2.0L or BODY, AIR CLEANER, REMOVAL AND INSTALLATION, 5.7L .

Courtesy of CHRYSLER GROUP, LLC

1 - Transmission Oil Cooler

2 - Transmission Oil Cooler Lines

NOTE:
Plug and seal the ends of the transmission fluid cooler and the transmission fluid cooler lines to prevent leakage of oil, or moisture, contaminates, or impurities from entering into the system.
Disconnect the transmission fluid cooler lines from the transmission oil cooler using (special tool #9546, Disconnect Tool).
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Remove the transmission skid plate. Refer to PLATE, SKID, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC

1 - Front Transmission Oil Cooler Line Bracket to Engine Oil Pan Bolt

2 - Rear Transmission Oil Cooler Line Bracket Bolt to Engine Oil Pan Bolt

3 - Transmission Oil Cooler Thermal Bypass Valve

Remove the transmission oil cooler line bracket to engine bolts.

Courtesy of CHRYSLER GROUP, LLC

1 - Transmission Oil Cooler Line to Transmission Bolt

2 - Transmission Oil Cooler line Quick Connect Fitting

3 - Transmission Oil Cooler Line Bundle

NOTE:

Plug and seal the ends of the transmission oil cooler fittings and the transmission oil cooler lines to prevent leakage of oil, or moisture, contaminates, or impurities from entering into the system.

Clean any dirt or debris from the areas of the transmission oil cooler line fittings.
Remove the transmission oil cooler line to transmission bolt and separate line from transmission.
Disconnect the transmission oil cooler line from the quick connect fitting using (special tool #9546, Disconnect Tool).
Remove the transmission oil cooler line bundle from the vehicle.