Possible Causes
WARNING: This page is about a different variant/trim than selected.
| Possible Causes |
|---|
| 5-VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE |
| 5-VOLT SUPPLY CIRCUIT OPEN |
| 5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND |
| 5-VOLT SUPPLY CIRCUIT SHORTED TO THE SENSOR GROUND CIRCUIT |
| CMP SENSOR 1/2 POSITION SIGNAL 2 CIRCUIT SHORTED TO VOLTAGE |
| CMP SENSOR 1/2 POSITION SIGNAL 2 CIRCUIT SHORTED GROUND |
| CMP SENSOR 1/2 POSITION SIGNAL 2 CIRCUIT SHORTED TO THE SENSOR GROUND |
| CMP SENSOR 1/2 POSITION SIGNAL 2 CIRCUIT OPEN/HIGH RESISTANCE |
| SENSOR GROUND CIRCUIT OPEN/HIGH RESISTANCE |
| CAMSHAFT POSITION SENSOR 1/2 |
| TONE WHEEL LOOSE OR DAMAGED |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .