Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR ANY SERVICE BULLETINS OR PCM SOFTWARE UPDATES
1. Check for any applicable Service Bulletins or Flash updates related to the DTC.
  Are there any applicable Service Bulletins or Flash updates?
  
  Yes
  - Make the applicable repair.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go To 2
READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
Did the DTC return?

Yes
- Go To 3
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
CHECK THE ANTILOCK BRAKE SYSTEM (ABS) MODULE FOR DTCS
1. Refer to the recorded DTCs.
  Are there any DTCs present in the ABS Module?
  
  Yes
  - Perform the applicable diagnostic procedure(s). Refer to: BRAKE SYSTEM CONTROL MODULE (BSCM) - DIAGNOSTIC CODE INDEX and/or BRAKE SYSTEM CONTROL MODULE 2 (BSCM 2) - DIAGNOSTIC CODE INDEX .
  No
  - Go To 4
CHECK THE OCCUPANT RESTRAINT CONTROLLER (ORC) FOR DTCS
1. Refer to the recorded DTCs.
  Are there any DTCs present in the ORC Module?
  
  Yes
  - Perform the applicable diagnostic procedure(s). Refer to: OCCUPANT RESTRAINT CONTROLLER (ORC) - DIAGNOSTIC CODE INDEX .
  No
  - Replace and program the Occupant Restraint Controller (ORC) in accordance with the Service Information. Refer to CONTROLLER, OCCUPANT RESTRAINT (ORC), REMOVAL AND INSTALLATION .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .