LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Grand Cherokee Altitude, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Hybrid Control Processor Module (HCP) - DTCS P1C8E-00 To P2535-00) >> DTC Troubleshooting >> P2532-00 Ignition Switch Run Position Circuit High >> Possible Causes

Possible Causes

WARNING: This page is about a different variant/trim than selected.
Possible Causes
IGNITION RUN CIRCUIT BETWEEN RUN/START RELAY AND PIM SHORTED TO VOLTAGE
IGNITION RUN RELAY IS STUCK ON (INTERNAL TO POWER DISTRIBUTION CENTER (PDC)
POWER INVERTER MODULE (PIM)

Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to  PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE  .