Set Condition
WARNING: This page is about a different variant/trim than selected.
- The Hybrid Control Processor (HCP) detects that the circuitry that is used to disable the electric motors is not functioning properly. The circuitry is temporarily disabled, and feedback from the motors does not indicate disabled or it does not return to enabled when the circuitry is enabled.
- This DTC may set if the electric motors are not functioning properly due to overheating, resolver or other DTCs present in the HCP.
- This DTC may set if the one of the Fused B+ feeds to the HCP is not present. This circuit that powers up the micro controller for drive motor disabling.