Diagnostic Test
CHECK FOR AN ACTIVE CONDITION
On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury.
Read the HIGH VOLTAGE SAFETY PROCEDURES. Refer to: HIGH VOLTAGE SAFETY PROCEDURES .
When the HIGH VOLTAGE POWER DOWN PROCEDURE is necessary. Refer to: HIGH VOLTAGE POWER DOWN .
- Repair all damage to the vehicle from the impact event.
Has all the vehicle impact damage been repaired?
Yes
With the scan tool, actuate the Hybrid Battery Active Discharge Fault Reset routine in the BPCM and perform the HCP VERIFICATION TEST. Refer to HYBRID CONTROL PROCESSOR (HCP) VERIFICATION TEST .