Removal And Installation: Right: Installation

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Prior to installation, make sure all gasket mating surfaces are clean and free of any debris.
• Position the exhaust manifold gasket and manifold to the cylinder head.
  NOTE:

  All fasteners removed must be installed in the same location they were removed from.

• The exhaust manifold to cylinder head bolts must be tightened in the sequence shown in the torque table below.
• Re-check the torque using the sequence shown.
• Start the engine and check for leaks.