LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Cherokee Trailhawk >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (2.4L Engine (Service Information) (1 Of 2)) >> Air Intake System >> Hose, Clean Air >> Removal

Hose, Clean Air: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the engine cover. Refer to COVER, ENGINE, REMOVAL .
    GC0186594Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the quick coupling (2) of the fresh air make up hose from the clean air hose (4).
  4. Loosen the clamp (5) and remove the clean air hose (4) from the throttle body inlet.
  5. Loosen the clamp (3) and remove the clean air hose (4) from the air cleaner body.
  6. Disengage the pushpins (1) and lift the clean air hose (4) to expose the Inlet Air Temperature (IAT) sensor connector on the bottom of the hose.
    GC0186907Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the electrical connector (1) from the IAT sensor and remove the clean air hose (2) from the vehicle.
scientia non olet · About LEMON Manuals