LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Cherokee Trailhawk >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 2.0L Engine (Service Information) (2 Of 2) >> Turbocharger System >> Sensor, Turbo Boost Pressure >> Removal

Sensor, Turbo Boost Pressure: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the top engine cover. Refer to COVER, ENGINE, REMOVAL .
    GC0181256Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connector (1) from the turbo boost pressure sensor (2).
    GC0181909Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolt (1) and remove the turbo boost pressure sensor (2).
    GC0187025Courtesy of CHRYSLER GROUP, LLC
  5. Inspect the O-ring (2) on the turbo boost pressure sensor (1).
scientia non olet · About LEMON Manuals