LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Cherokee Trailhawk >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 2.0L Engine (Service Information) (2 Of 2) >> Lubrication >> Pick-Up, Oil Pump >> Installation >> Oil Pump Pick-Up - TRAILHAWK

Oil Pump Pick-Up - TRAILHAWK

GC0181878Courtesy of CHRYSLER GROUP, LLC
  1. Install a new O-ring seal (1) on the oil pump pick-up tube.
    Fig 1: Oil Pump Pick-Up Tube Screws Tightening Sequence
    GC0186597Courtesy of CHRYSLER GROUP, LLC
  2. Install the oil pump pick-up tube and tighten the screws in the sequence shown in illustration to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  3. Install the lower oil pan. Refer to PAN, OIL, INSTALLATION .
  4. If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level. Refer to ENGINE OIL, STANDARD PROCEDURE .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  6. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals