Audio/Video/Entertainment/Connectivity (Service Information): Radio: Installation

NOTE:

It may be necessary to be record the serial number on the back of the new radio to get the security code to unlock the radio.

Position the radio near the instrument panel.

Courtesy of CHRYSLER GROUP, LLC
Connect the antenna (2) and wire harness connectors (1).
Connect the USB connectors (3).

Courtesy of CHRYSLER GROUP, LLC
Position the radio into the cavity in the instrument panel.
Install the fasteners (1) securing the radio (2) to the instrument panel. Tighten the fasteners securely.
Install the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
NOTE:
If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

NOTE:
Uconnect® Access Applications and WiFi hotspot will be automatically updated in the replacement radio through the radio's embedded cellular phone based on the customers present subscription status. This update process may take up to an hour, depending upon the number of apps and adequate cellular services accessibility. The dealer is not expected to perform this process or to oversee it, but may need to explain to the vehicle owner or operator that some features and applications may not be fully restored and overall system response may be slowed until the process has completed.