LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Cherokee Altitude LUX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (2.0L Engine (Service Information) (2 Of 2)) >> Turbocharger System >> Lines, Tubes And Hoses, Turbocharger, Oil And Coolant >> Removal >> Turbocharger Coolant Supply Pipe

Turbocharger Coolant Supply Pipe

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Drain the coolant system. Refer to COOLING SYSTEM, STANDARD PROCEDURE .
  4. Remove the catalytic converter. Refer to CONVERTER, CATALYTIC, REMOVAL .
    GC0187015Courtesy of CHRYSLER GROUP, LLC
  5. Remove the bolt (3) from the turbocharger oil supply pipe on the turbocharger.
  6. Remove the nut (2) securing the oil dipstick tube, engine coolant pipe and the turbocharger oil supply pipe (1) to the turbocharger.
  7. Remove and reposition the turbocharger oil supply pipe (1) complete with O-ring seal.
    GC0181777Courtesy of CHRYSLER GROUP, LLC
  8. Remove the two bolts (1) and remove the turbocharger coolant supply pipe (2) from the turbocharger.
    GC0187171Courtesy of CHRYSLER GROUP, LLC
  9. Disengage the wire harness retainers (1) from the turbocharger coolant supply pipe.
    GC0182842Courtesy of CHRYSLER GROUP, LLC
  10. Loosen the band clamp (1) and remove the cooling hose (2) from the turbocharger coolant supply pipe (4).
  11. Remove the bolt (3) and remove the turbocharger coolant supply pipe (4) from the engine.
scientia non olet · About LEMON Manuals