LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Cherokee Altitude LUX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (2.0L Engine (Service Information) (2 Of 2)) >> Manifolds >> Manifold, Exhaust >> Installation >> Exhaust Manifold Heat Shield

Exhaust Manifold Heat Shield

WARNING: This page is about a different variant/trim than selected.
GC0187042Courtesy of CHRYSLER GROUP, LLC
  1. Install a NEW  exhaust manifold heat shield assembly (1) and tighten the bolts (2) to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  2. Install the turbocharger. Refer to TURBOCHARGER, INSTALLATION .
  3. If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level. Refer to ENGINE OIL, STANDARD PROCEDURE .
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  5. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals