LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Cherokee Altitude LUX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (2.0L Engine (Service Information) (2 Of 2)) >> Lubrication >> Separator, Oil >> Removal

Separator, Oil: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Drain the cooling system. Refer to COOLING SYSTEM, STANDARD PROCEDURE .
  4. Remove the intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL .
    GC0186703Courtesy of CHRYSLER GROUP, LLC
  5. Disengage the four engine wiring retaining clips (1).
    GC0186456Courtesy of CHRYSLER GROUP, LLC
  6. Remove and discard the bolts (2) and remove the engine oil vapor separator (1).
    GC0186421Courtesy of CHRYSLER GROUP, LLC
  7. Remove the gasket (2) from the engine oil vapor separator (1).
scientia non olet · About LEMON Manuals