LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Cherokee Altitude LUX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (2.0L Engine (Service Information) (2 Of 2)) >> Lubrication >> Sensor, Oil Pressure And Temperature >> Removal

Sensor, Oil Pressure And Temperature: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Remove the Accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
  4. Remove the bolts securing the generator and set aside to gain access to the sensor.
    GC0181030Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the wire harness connector (1) from the engine oil pressure and temperature sensor (2).
  6. Unscrew and remove the engine oil pressure and temperature sensor (2).
    GC0180984Courtesy of CHRYSLER GROUP, LLC
  7. Remove the sealant residues from the threaded hole on the engine block.
scientia non olet · About LEMON Manuals