LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Cherokee Altitude LUX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (2.0L Engine (Service Information) (2 Of 2)) >> Lubrication >> Sensor, Oil Pressure And Temperature >> Installation

Sensor, Oil Pressure And Temperature: Installation

WARNING: This page is about a different variant/trim than selected.
GC0181017Courtesy of CHRYSLER GROUP, LLC
  1. Install the engine oil pressure and temperature sensor (1) and tighten it to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  2. Connect the wire harness connector (2) to the engine oil pressure and temperature sensor.
  3. Position the generator, install the bolts and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  4. Install the Accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  6. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals