Standard Procedure - Transmission Cooler Line Quick Connect Fitting Disconnect/Connect: Connect
WARNING: This page is about a different variant/trim than selected.
| 1 - QUICK CONNECT FITTING |
| 2 - CLIP |
| 3 - OIL COOLER LINE |
| 4 - DUST CAP |
- Align transmission cooler line (3) with quick connect fitting (2) while pushing straight into the fitting.
- Push in on transmission cooler line (3) until a "click" is heard or felt.
- Slide dust cap (4) down the transmission cooler line (3) and snap it over the quick connect fitting (2) until it is fully seated and rotates freely. Dust cap will only snap over quick connect fitting when the transmission cooler line is properly installed.
NOTE:
If dust cap will not snap into place, repeat connection step #2.