Tubes And Hoses, Transmission Oil Cooler: Installation
WARNING: This page is about a different variant/trim than selected.
- Position transmission cooler line bundle (1) in vehicle.
- Connect the transmission cooler lines (1) at transmission fittings. Refer to COOLING/TRANSMISSION/TUBES AND HOSES, TRANSMISSION OIL COOLER/STANDARD PROCEDURE .
- Lower the vehicle.
- Connect the transmission cooler lines (4, 5) to the cooler. Refer to COOLING/TRANSMISSION/TUBES AND HOSES, TRANSMISSION OIL COOLER/STANDARD PROCEDURE .
- Raise the vehicle.
- Install the transmission cooler line support brace bolt (1).
- Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
- Install the belly pan. Refer to BELLY PAN, INSTALLATION .
- Start engine and check transmission fluid level. Adjust fluid level as necessary. Refer to FLUID AND FILTER, STANDARD PROCEDURE .