Tube, Fuel Tank Filler: Installation
WARNING: This page is about a different variant/trim than selected.
- Install fuel filler tube into the fuel door housing assembly.
- Install fuel filler tube to the fuel tank and tighten the hose clamp (1) to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
- Install filler tube mounting bracket nut (2) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
- Install the ABS wire harness to the holder (1).
- Attach line to retainer (3) and connect the fuel tube vent line (2) quick connect fitting.
- Connect the fuel tank pressure sensor wire harness connector (1).
- Install the right rear wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.