Sensor, Fuel Pressure: Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
The fuel system is under constant pressure even with engine off. Before servicing the fuel rail, fuel system pressure must be released.
- Perform the Fuel System Pressure Release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE .
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the engine cover. Refer to COVER, ENGINE, REMOVAL
.
- Disconnect the Fuel Pressure Sensor wire harness connector (1).
- Disconnect the fuel supply hose quick connects (2) and remove the fuel line assembly. Refer to QUICK-CONNECT FITTINGS .