When Monitored And Set Conditions
When Monitored: continuously when the following condition is met:
- Ignition on
Set Conditions:
- This DTC sets if the HVAC Module detects a short to ground on the A/C compressor control circuit.
Default Actions:
- If the HVAC Module detects a valid current draw, the DTC will change from Active to Stored and will stay in the controllers memory for 100 ignition cycles.
| Possible Causes |
|---|
| A/C COMPRESSOR CONTROL CIRCUIT SHORTED TO GROUND |
| A/C COMPRESSOR |
| HVAC MODULE |
Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .