Diagnostic Test

DETERMINE ACTIVE OR STORED DTC
NOTE:
Make sure the battery is fully charged.
1. Turn the ignition on.
2. Perform ORC module reset. Access the Miscellaneous Function menu from the ORC ECU Overview screen on the scan tool to perform this operation.
3. With the scan tool, read ORC DTCs.
  Is the DTC active or stored?
  
  ORC - ACTIVE DTC
  - Go To 2
  ORC - STORED DTC
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
CHECK FOR ADDITIONAL ACTIVE SQUIB DTCS
1. With the scan tool, read ORC DTCs.
  Are there squib specific DTCs set as active in addition to B1BB9-00-AIRBAG SQUIB CIRCUIT COUPLING?
  
  Yes
  - Repair all other active squib specific DTCs before repairing B1BB9-00-AIRBAG SQUIB CIRCUIT COUPLING. Refer to DTC INDEX .
  No
  - Go To 3
USE THE SCAN TOOL TO IDENTIFY THE COUPLED CIRCUITS
1. With the scan tool, identify the two or more Squib circuits that read SET. To find out which squibs are coupled, Go to Read/Write Data,'Squib Coupling Status' - check 'FAIL' squibs.
  Are two or more Squib circuits SET?
  
  Yes
  - Repair the two or more Squib circuits for a Squib Circuit Coupling condition.
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .