Battery System
WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS - BATTERY SYSTEM
| DESCRIPTION | TORQUE SPECIFICATION | COMMENT |
|---|---|---|
| B+ Battery Positive at Power Distribution Center (PDC) | 8 N. m (71 In. Lbs.) | - |
| Battery Negative to Negative Post | 7 N. m (62 In. Lbs.) | - |
| Battery Positive Cable | 7 N. m (62 In. Lbs.) | - |
| Battery Positive B+ at Bulkhead Captured Nut | 15 N. m (11 Ft. Lbs.) | - |
| Battery Positive B+ at Bulkhead Isolator Nut | 6 N. m (53 In. Lbs.) | - |
| Battery Positive to Positive Post | 7 N. m (62 In. Lbs.) | - |
| Battery Bracket Bolt - Battery Hold Down to Tray | 5 N. m (44 In. Lbs.) | - |
| Battery Tray Bolts | 10 N. m (89 In. Lbs.) | - |
| Intelligent Battery Sensor (IBS) Sensor to Negative Post | 5 N. m (44 In. Lbs.) | - |
| Negative Battery Cable to the IBS | 11 N. m (8 Ft. Lbs.) | - |
| Battery Negative Lead to Fender | 20 N. m (15 Ft. Lbs.) | - |
| Negative Battery Cable to Engine Block | 20 N. m (15 Ft. Lbs.) | - |
| Negative Battery Cable to Engine Block - 5.7L | 41 N. m (30 Ft. Lbs.) | - |
| PDC to Wiring Connector | 4 N. m (35 In. Lbs.) | - |
| PDC to B+ | 12 N. m (9 Ft. Lbs.) | - |
| PDC Tray To Cross Beam Nuts | 8 N. m (71 In. Lbs.) | - |