Gear Shift Knob

REMOVAL

NOTE:

Most shift knobs can be remove by hand. The motion should mimic that of a slide hammer. Constant force does not aid in the removal of the knob.

Slide the shift lever back towards the seat and pull the shift knob in an upward motion with a "quick" snap to remove the shift knob from the lever. If removal of the shift knob by hand is not possible, wrap a shop towel or equivalent around the base of the shift knob. Then, using puller (special tool #C-4333A, Puller, Pulley) or equivalent and a slide hammer, remove the shift knob from the shift lever.

Courtesy of CHRYSLER GROUP, LLC

1 - Shift Knob

INSTALLATION

Courtesy of CHRYSLER GROUP, LLC

1 - Shift Knob

Install the shift knob on the shift lever and firmly push the shift knob down. An audible click should be heard when the shift knob is seated in position.