Diagnostic Test

Was the TPM Module replaced during the test procedure?

Yes 

• Go To  2

No 

• Go To  3

1. Perform Tire Pressure Monitoring (TPM) system module programming as needed.

   Using (special tool #2046300080, Kit, TPM/RKE ANALYZER) and the scan tool, navigate to the TPM system module and then its "Miscellaneous Functions" menu to select and perform the following procedures:

   1. Program Left Front Tire Sensor ID
   2. Program Left Rear Tire Sensor ID
   3. Program Right Front Tire Sensor ID
   4. Program Right Rear Tire Sensor ID
2. Drive the vehicle for a minimum of 20 minutes while maintaining a continuous speed above 24 km/h (15 mph).
3. With the scan tool, read TPM DTCs.

Are there any DTCs present?

Yes 

• Repair not complete, perform the appropriate diagnostic procedure. Refer to DTC INDEX (1 OF 2) and/or DTC INDEX (2 OF 2) .

No 

• Go To  3

1. Using an updated TPM-RKE Analyzer Tool, select TPM Functions, then enter the Model Year and the Body Style of the vehicle, and for the Trigger Selection select PARK SENSOR
2. Scan each TPM Sensor at each road wheel, and store each TPM Sensor ID in the correct location. (LEFT FRONT, LEFT REAR, RIGHT FRONT, RIGHT REAR, and SPARE TIRE (if equipped).)
3. Using the Scan Tool, Go to "TPM", then "Misc Function" and choose the corresponding wheel to Program the Sensor ID. (ID can be obtained on Sensor itself or can be read via the TPM-RKE Analyzer tool)
4. Drive the vehicle for a minimum of 20 minutes while maintaining a continuous speed above 24 km/h (15 mph).
5. With the scan tool, read TPM DTCs.

Are there any TPM DTCs present?

Yes 

• Perform the appropriate diagnostic procedure. Refer to DTC INDEX (1 OF 2) and/or DTC INDEX (2 OF 2) .

No 

• Repair complete.