LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2022 >> Gladiator Mojave, Part Time T/Case Control, Standard Trans >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> (Tire Pressure Module (TPM) - Electrical Diagnostics) >> DTC Troubleshooting >> C2209-00-Tire Pressure Monitor Internal- >> Diagnostic Test

Diagnostic Test

  1. CHECK FOR ACTIVE DTCS BEFORE AND AFTER DRIVING VEHICLE. 
    1. Check for and remove any non-FCC compliant components.
    2. Verify that all tire pressures are to the recommended cold inflation tire pressure specifications.
    3. Turn the ignition on.
    4. With the scan tool, read DTCs and record on the repair order.
    5. Test drive the vehicle at a speed greater than 24 km/r (15 mph) for 20 minutes in order to receive TPM data and allow for the system to update.
    6. With the scan tool, read DTCs in the TPM Module.

      Is the DTC active?

      Yes 

      • Go To  2

      No 

  2. CHECK TPM AND RELATED MODULE HARNESS CONNECTIONS 
    1. Disconnect the TPM harness connector.
    2. Disconnect all related in-line harness connections (if equipped).
    3. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
      • Proper connector installation.
      • Damaged connector locks.
      • Corrosion.
      • Other signs of water intrusion.
      • Weather seal damage (if equipped).
      • Bent terminals.
      • Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
      • Terminals that have been pushed back into the connector cavity.
      • Perform a terminal drag test on each connector terminal to verify proper terminal tension.

      Repair any conditions that are found.

    4. Connect the TPM harness connector. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
    5. Connect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
    6. Connect all related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
    7. With the scan tool, erase DTCs.
    8. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
    9. With the scan tool, read TPM DTCs.

      Did the DTC return?

      Yes 

      No 

scientia non olet · About LEMON Manuals