Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
Did the DTC return?

Yes
- Go To 2
No
- Perform the Intermittent DTC Procedure. Refer to INTERMITTENT DTC PROCEDURE .
USE THE TPM-RKE ANALYZER TO CHECK TIRE PRESSURE MONITORING (TPM) SENSOR ID(S)
NOTE:
Always be certain to select the proper vehicle line and model year when using this tool, as the tool will automatically use the correct protocol to attempt to read the Sensor. If the incorrect vehicle line and/or model year is selected, the Sensor will not respond to the tool.

NOTE:
If you receive no response from any of the tire pressure sensors, check to make sure that the TPM-RKE Analyzer is set correctly, and repeat the process on each of the non-responsive wheel(s)
1. Use a TPM-RKE Analyzer (special tool #2046300080, Kit, TPM/RKE ANALYZER) to scan each TPM Sensor for an ID, store in the proper location in the TPM-RKE Analyzer.
2. Use a TPM-RKE Analyzer to upload the correct IDs and proper locations in the scan tool.
3. With the scan tool, select the TPM Module under "Miscellaneous Functions", follow the procedure for uploading TPM Sensor IDs.
4. With the scan tool, erase TPM Module DTCs.
5. Test drive the vehicle at a speed greater than 24 km/h (15 mph) for 20 minutes in order to receive TPM data and allow for the system to update.
6. With the scan tool, check to see if the TPM sensor IDs match what is programmed into the TPM Module.
Is the correct TPM Sensor installed on the vehicle?

Yes
- Test complete.
- Perform the TPM VERIFICATION TEST. Refer to TPM VERIFICATION TEST .
No
- Install the correct Tire Pressure Monitoring (TPM) Sensor in accordance with the Service Information. Refer to MODULE, TIRE PRESSURE MONITORING (TPM), REMOVAL AND INSTALLATION .
- Perform the TPM VERIFICATION TEST. Refer to TPM VERIFICATION TEST .