LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2022 >> Gladiator Mojave, Part Time T/Case Control, Standard Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Plumbing >> Oil, Refrigerant >> Standard Procedure >> Compressor Oil Drain Procedure - PHEV

Compressor Oil Drain Procedure - PHEV

CAUTION:

Be certain to adjust the refrigerant system oil level when replacing an A/C compressor. Failure to properly drain and measure the refrigerant oil from the A/C compressor can prevent the A/C system from operating as designed and cause serious compressor damage.

NOTE:

If no oil remains in the old A/C compressor the total system oil amount should be added. Refer to CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS .

  1. Remove the old A/C compressor from the vehicle and empty all of the refrigerant oil from the A/C compressor ports into a clean measured container.
  2. Fill the new A/C compressor with the same amount of refrigerant oil that was emptied out of the old A/C compressor into the ports on the new A/C compressor. Use only clean refrigerant oil of the type recommended for the A/C compressor in the vehicle.
  3. Install the new A/C compressor onto the engine. Refer to COMPRESSOR, A/C, REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals