Engine Oil Level Check
WARNING: This page is about a different variant/trim than selected.
NOTE:
The engine must be HOT when checking oil level.
CAUTION:
Do not operate engine if the oil level is above the MAX mark on the dipstick. Excessive oil volume can cause oil aeration which can lead to engine failure due to loss of oil pressure or increase in oil temperature.
- The best time to check engine oil level is after the engine is at operating temperature. Allow the engine to be shut off for at least 5 minutes before checking oil level.
- Checking the oil while the vehicle is on level ground will improve the accuracy of the oil level reading. When pulling the dipstick out often times oil will stick to the dipstick guide tube and give a higher than actual reading. Remove the dipstick and observe oil level. It may be necessary to flip the dipstick over on the back side of the dipstick to obtain an accurate reading. Add oil only when the level is at or below the SAFE mark. If the oil level is in the safe range, do not add oil.