Combustion Leakage Test - Without Pressure Tester

WARNING: This page is about a different variant/trim than selected.

WARNING:

Do not remove cylinder block drain plugs or loosen radiator draincock with system hot and under pressure. Serious burns from coolant can occur.

CAUTION:

Avoid overheating. Do not operate engine for an excessive period of time. Open draincock immediately after test to eliminate boil over.

Add coolant to radiator to bring level to within 6.3 mm (1/4 in) of the top of the thermostat housing.
Start engine and accelerate rapidly three times, to approximately 3000 rpm while observing coolant. If internal engine combustion gases are leaking into cooling system, bubbles will appear in coolant. If bubbles do not appear, internal combustion gas leakage is not present.