Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN
- With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
- With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
- With the scan tool, erase all DTCs.
- Turn the ignition off for a minimum of 10.0 seconds.
- Turn the ignition on.
- Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read DTCs.
Did the DTC return?
Yes
- Go To 2
No
- Perform the TESTING FOR AN INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
- CHECK THE TRANSMISSION CONTROL MODULE (TCM) SOFTWARE
- Check for any applicable Service Bulletins or software updates that are applicable.
Were any applicable software updates available?
Yes
- With the scan tool, Program the TCM with the latest calibrations in accordance with the Service Information. Refer to MODULE PROGRAMMING .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to 8HP50/850RE TRANSMISSION VERIFICATION TEST .
No
- Go To 3
- Check for any applicable Service Bulletins or software updates that are applicable.
- CHECK WIRING AND CONNECTORS
- The conditions necessary to set the DTC are not present at this time.
- Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
- Wiggle the wires while checking for shorted and open circuits.
- Check for any Service Bulletins that may apply.
Were any problems found?
Yes
- Repair as necessary.
- Perform the TRANSMISSION VERIFICATION TEST. Refer to 8HP50/850RE TRANSMISSION VERIFICATION TEST .
No
- If no problems are found, replace and program the TCM in accordance with the Service Information. Refer to MODULE, TRANSMISSION CONTROL (TCM), REMOVAL AND INSTALLATION .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to 8HP50/850RE TRANSMISSION VERIFICATION TEST .