Set Condition
WARNING: This page is about a different variant/trim than selected.
- Condition One:
- A short to ground failure is detected if the voltage of the output signal during PWM duty or no duty phase is less than a calibrated value.
- A short to ground failure is detected if the voltage of the output signal during PWM duty phase is less than a calibrated value.
- Condition Two:
- A short to ground failure is detected if the voltage of the output signal during PWM duty phase is less than a calibrated value.
- Condition Three:
- A short to ground failure is detected if the commanded duty cycle for the solenoid is 100% and the ASIC indicates the output stage is switched off.