Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN
- With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
- With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
- With the scan tool, erase all DTCs.
- Turn the ignition off for a minimum of 10.0 seconds.
- Turn the ignition on.
- Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read DTCs.
Did the DTC return?
Yes
- Go To 2
No
- Perform the TESTING FOR AN INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
- CHECK FOR CONDITIONS THAT COULD CAUSE OVERHEATING
- Check for the following conditions:
- Incorrect Transmission Fluid level. Refer to CHECK FLUID LEVEL .
- Case vent plugged or damaged.
- Transmission Cooler air flow restriction.
- Fluid restriction in the Transmission Cooler.
- Bad Torque Converter.
Were any problems found?
Yes
- Repair the condition as necessary.
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .
No
- Replace and program the TCM in accordance with the Service Information. Refer to MODULE, TRANSMISSION CONTROL (TCM), REMOVAL AND INSTALLATION .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .
- Check for the following conditions: