Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR AN ACTIVE DTC
- Turn the ignition on.
- With the scan tool, read DTCs and record on the repair order.
Is the DTC active or pending?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT DTC .
- CHECK THE ANTI-LOCK BRAKE MODULE FOR BPP SENSOR FAULTS
- With the scan tool, read DTCs in the ABS Module.
Is the ABS Module setting any DTCs against a Brake Pressure Sensor?
Yes
- Perform the diagnostic procedure in the ABS Module. Refer to DTC INDEX (1 OF 2) and/or DTC INDEX (2 OF 2) .
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
No
- Replace the ABS Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM (ABS), REMOVAL AND INSTALLATION .
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
- With the scan tool, read DTCs in the ABS Module.