LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2022 >> Gladiator Mojave, Part Time T/Case Control, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> 3.6L Engine (Service Information) (2 Of 3) >> Lubrication >> Diagnosis And Testing >> Checking Engine Oil Pressure

Checking Engine Oil Pressure

multimedia:A supplement to the article is available.
  1. Remove the oil filter and cap. Refer to FILTER, ENGINE OIL, REMOVAL AND INSTALLATION .
  2. Transfer the oil filter to the (special tool #2021500090, Adapter, Late Version 3.6L Oil Pressure Test)
  3. Install Pressure Gauge (special tool #C-3292A, Gauge, Pressure) to the Oil Pressure Test Adapter.
  4. Install the Oil Pressure Test Adapter to the engine and securely tighten.
  5. Start and idle the engine. If oil pressure is 0 at idle, shut off the engine and consult the Engine Lubrication and Diagnostic Table. Refer to ENGINE LUBRICATION DIAGNOSTIC TABLE .
  6. Verify that the engine has acceptable oil pressure. Refer to ENGINE SPECIFICATIONS .
scientia non olet · About LEMON Manuals