Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
Did the DTC return?

Yes
- Go To 2
No
- Perform the appropriate INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK THE RELATED TV ANTENNA CONNECTION AT THE DTV MODULE
1. Turn the ignition off.
2. Verify that the related TV Antenna cable and connections are secure and undamaged.
  Are the connection(s) secure and undamaged?
  
  Yes
  - Go To 3
  No
  - Repair the connection(s) as needed.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
DISCONNECT THE TV ANTENNA CONNECTOR AT THE DTV MODULE - ERASE DTCS AND CHECK FOR DTC TO RETURN
1. Turn the ignition off.
2. Disconnect the related TV Antenna connector at the DTV Module.
  NOTE:
  The short to ground DTC should not set. An open circuit DTC should set in the DTV with the antenna disconnected.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
  Did the short to ground DTC return?
  
  Yes
  - Replace the DTV module.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the related TV Antenna and the coax cable.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .