Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
3. NOTE: A front door must remain open whenever checking or erasing Radio DTCs.
4. With the scan tool, record and erase the Radio DTCs.
5. Cycle the ignition switch from on to off, wait five seconds and then back to on.
6. Turn the Radio on and set the volume to 25.
7. Adjust the speakers to the front and center.
8. With the scan tool, read the active Radio DTCs.
NOTE:
A front door must remain open whenever checking or erasing Radio DTCs.

Did the DTC return?

Yes
- Go To 2
No
- Perform the appropriate INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK THE CABIN EQUALIZATION CURVE NUMBER
1. With the scan tool in the BCM ECU Details Tab, Configuration button, record the Cabin Equalization Curve number.
2. With the scan tool in the Radio ECU Details Tab, Configuration button, record the True value.
  NOTE:
  The Cabin EQ Curve value found in the BCM should match the True value found in the Radio.
  
  Do the Cabin EQ settings match one another?
  
  Yes
  - Replace the Radio in accordance to the service information. Refer to RADIO, REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
VERIFY COMMUNICATION WITH BCM
1. With the scan tool, read the active modules on the BUS.
  Does the scan tool show the BCM active on the BUS?
  
  Yes
  - Go To 4
  No
  - Perform the No Response From ECU diagnostic procedure. Refer to NO RESPONSE FROM ECU .
CHECK THE BCM FOR ACTIVE DTCs
1. With the scan tool, erase BCM DTCs.
2. Turn the ignition off. Wait approximately 10 seconds.
3. Turn the ignition on.
4. With the scan tool, read BCM DTCs and record them on the repair order.
  Are any active DTCs present?
  
  Yes
  - Perform the appropriate diagnostic procedure. Refer to DTC INDEX (1 OF 2) and/or DTC INDEX (2 OF 2) .
  No
  - Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL (BCM), REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .